Have a question about our LED Bed light Kit or troubleshooting a problem?

Check out this list of common questions to find the answer you are looking for!


Will these fit with a tonneau cover over my bed? . . .

Yes!

Will these fit all bed sizes? . . .

Yes!

Do you have the wireless option avialable? . . .

No, we apologize but the wireless option is still in testing.

Can I install an inline switch to power this kit? . . .

Yes, you certianyl can. One is not included and you may need to run power to the switch directly from your battery depending on your disired results.

What will turn these lights on? . . .

The lights will actiavte with the opening of a door, or unlocking of the doors with your remote key. You can turn the bed lights on and off permantently by turning your OEM interior dash light control all the way to permanent on setting.

What will turn these lights off? . . .

Unless they are set to permanent on with your in dash switch, the lights will fade similiar to your puddle lamps. (typically about 45 seconds)

I am having a hard time getting my lights to stay and not fall. . . .

Proper isntall is very important, if done correctly the lights will last through inclement weather, extreme temperatures, and not fall down etc. A clean mounting surface and copiuos RTV silicone during isntall are critical. If post-install you are having trouble with the lights staying, please apply more silicone and be sure to hold each section in place for a few minutes each as you progress down the strip.

Approx how long is each light? . . .

The running board light stip is approx 62" in length on each side.

Will this work for my shorter cab or extended cab truck? . . .

Yes!

Can I get them in a different color? . . .

Currently we offer the lights in cool white, but if you are looking for something custom please contact us.

Will these lights hold up to snow, car washes, etc.? . . .

Yes! Proper isntall is important, but if done correctly the lights will last through inclement weather, extreme temperatures, etc. A clean mounting surface and copiuos RTV silicone during isntall are critical.

I have a 2015, how do i get the wire into the truck? . . .

If you remove the door sill panel, you will see a white plastic tab (push tab configuration) You will simply need to drill a small hole in this plastic tab to run your wire through.

Can I install this kit at the same time with a running board step light kit? . . .

Yes,they install very similarly and with the same connection points so you can certianly install them in tandem.


Not what you are looking for?